Quote:
Originally Posted by knc1
How does Kubrick configure the host networking?
Why:
Could some of these strange failure cases be IP address conflicts with other devices?
Or do you **ONLY** configure and route to usb0 ?
|
It doesn't do it at all (well, almost). The network setup is left to the diags partition (which will wait for the user to turn on the network, and then always configure itself to 192.168.15.244). Kubrick only waits for a usb network interface to show up, and then configures it to 192.168.15.201.
See
constants,
prepare_network.sh (and dig your way back up through the Java sources starting at
Executables.java, if you want
)