|
Conversion Problem
Hello Willus,
Most of the time, I am facing a problem when using fit-with mode.
It is not annoying or it does not make reading a problem, but I am really curious about it...
I enclose source and output file. Please check in output file the gap at the bottom of pages 1,2,3,5,9,12,13.
There is also a shorter gap at the top of pages 1,5,14.
Sometimes (but not in this example) there are both long gaps at both top and bottom at the same page.
Any idea why is that happening?
Command-line version of options:
-mode fw -gui+ -ls-
Thank you
Angelos
|