MobileRead Forums - View Single Post - PRS-T1 Sony PRS-T1Russian rooted after restored factory settings does not work anymore!

matteos72 · 03-10-2012, 11:26 AM

hello
I have rooted my sony PRS-T1 with the Russian minimal set here https://wiki.mobileread.com/wiki/PRST...#Russification

I also upgraded the last firmware from sony taken here
http://www.sony.it/support/it/produc...PC_v1004_12210

It worked well but I was not so happy about some settings. SoI decided to reset the reader following your instructions in this forum that links here
http://www.kb.sony.com/selfservice/d...nalId=C1024494

I followed exactly the steps indicated before. When the Sony asked me if I wanted to restore factory settings I press YES.

The the SOny rebooted and after "opening reader" there is nothing! The screen blinks in series white/black/white/black
If i connect the reader to the PC I see two new mass storages units (I use WIndows) J, and K but I cannot access (because I cannot tell the reader to put itself in mass storage mode as on its screen I do not see anything!)

can you help me?

03-10-2012, 11:26 AM	#1
matteos72 Enthusiast Posts: 26 Karma: 10 Join Date: Feb 2012 Device: Sony PRS-T1	Sony PRS-T1Russian rooted after restored factory settings does not work anymore! hello I have rooted my sony PRS-T1 with the Russian minimal set here https://wiki.mobileread.com/wiki/PRST...#Russification I also upgraded the last firmware from sony taken here http://www.sony.it/support/it/produc...PC_v1004_12210 It worked well but I was not so happy about some settings. SoI decided to reset the reader following your instructions in this forum that links here http://www.kb.sony.com/selfservice/d...nalId=C1024494 I followed exactly the steps indicated before. When the Sony asked me if I wanted to restore factory settings I press YES. The the SOny rebooted and after "opening reader" there is nothing! The screen blinks in series white/black/white/black If i connect the reader to the PC I see two new mass storages units (I use WIndows) J, and K but I cannot access (because I cannot tell the reader to put itself in mass storage mode as on its screen I do not see anything!) can you help me? Last edited by matteos72; 03-10-2012 at 11:29 AM.