MobileRead Forums - View Single Post - (Perhaps) The best firmware for the HANLIN/BEBOOOK and OEM family again!

jane10021 · 02-01-2011, 04:05 AM

Well, I did. I tried first 2.7, and everything seemed to go well untill I was 30 pages into the book, then the buttons of my reader freezed. Only switching it off worked, but I could read no book. So I tried 2.8 and that had the same result. All buttons freeze, I cannot use it, turn pages anymore.
Is this problem normal?
I tried mobi and prc format books.

I went back to the Hanlin (jinke) firmware, but that crashes all the time.

02-01-2011, 04:05 AM	#107
jane10021 Member Posts: 17 Karma: 10 Join Date: Jan 2011 Device: hanlin V3, pocketbook 360	Well, I did. I tried first 2.7, and everything seemed to go well untill I was 30 pages into the book, then the buttons of my reader freezed. Only switching it off worked, but I could read no book. So I tried 2.8 and that had the same result. All buttons freeze, I cannot use it, turn pages anymore. Is this problem normal? I tried mobi and prc format books. I went back to the Hanlin (jinke) firmware, but that crashes all the time.