Quote:
Originally Posted by alaya129
No , only the "Starting up ..." message . (I wait 10 minutes)
|
Very strange. Let's try the 10 times reset method one more time. I changed the steps a bit because the one in the wiki can be confusing and causing the procedure not to work.
1. Use a paper clip or pin to depress the reset button in the small hole on the back of the unit. Turn the unit on.
2. Wait until the "Starting up..." page is displayed for a few seconds and you see the orange LED blinking. Just count like 3 to 4 sec. from the moment you see the LED blinking.
3. Repeat steps 1 and 2 ten times.
4. On the tenth reset let the Reader boot and after a few minutes the message "Firmware update is not finished correctly. Please execute firmware update again." will be displayed.
5. Connect the USB cable and the device will automatically go into recovery ("Updating firmware now...") mode.
6. Flash the device with the original PRS500 updater.