Quote:
Originally Posted by ixtab
... do you read thread titles, or responses to your questions?
1. This thread is clearly for K4 and K5, not for K3.
2. geekmaster replied in your other thread. "No soldering to a K3 circuit board, and no need to remove the back cover. It has an external serial port connector in the lower slot on the left edge."
|
Perhaps our current (and old) Kindle model names are not clear to all, so here they are:
Kindle model names used in this forum:
DX : 9.7-inch eink, white bezel, 2.x firmware (unofficial 3.x upgrade)
DXG: 9.7-inch Pearl eink, graphite (dark gray) bezel, 2.x firmware (unofficial 3.x upgrade)
K3: Kindle 3 Keyboard, 6-inch Pearl eink, graphite (or white) bezel, 3.x firmware
K4: Kindle 4 Mini, 6-inch Pearl eink, dark silver bezel, 4.x firmware
K5: Kindle 5 Touch, 6-inch Pearl eink, dark silver bezel, 5.x firmware
K3G: alternate name for K3 with 3G.
K3w: old name for K3 wifi-only.
K4NT: old name for K4, when people were confused by K4 and K5 released close together.
Touch: old name for K5.
KT: old name for K5.
I hope that this clears up any potential confusion.