Well, I added a current sense resistor (1 Ohm) to the setup, and connected a scope.
X axis is time, 1 second per grid. Y axis is current, 100mA per grid.
The small "1->" marks the zero current line.
Screenshots were done the lotech way, with a camera.
First some measurements with files in internal memory:
Turning the reader on then off again, Baen RTF file, internal memory:
Page turn, Baen RTF file, internal memory:
Page turn, PDF file ('1984'), internal memory:
Next with files on SDcard (Sandisk 1GB):
Page turn, Baen RTF file, SDcard:
Another page turn, Baen RTF file, SDcard:
Page turn, PDF file (Atmel datasheet, with graphics), SDcard:
And another test set with a Sony MSmicro (512MB) with MS adapter:
Page turn, Baen RTF file, MSmicro:
Another page turn, Baen RTF file, MSmicro:
yet another page turn, Baen RTF file, MSmicro:
Page turn, PDF file (Atmel datasheet, with graphics), MSmicro:
RTF formatting + update of wait symbol, Baen RTF file, MSmicro:
Conclusions, anyone?
^_^