Thread: Stopping Calibre from checking when device=hard drive
View Single Post
Old 01-05-2012, 06:47 PM   #4
theducks
Well trained by Cats
theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.theducks ought to be getting tired of karma fortunes by now.
 
theducks's Avatar
 
Posts: 29,779
Karma: 54830978
Join Date: Aug 2009
Location: The Central Coast of California
Device: Kobo Libra2,Kobo Aura2v1, K4NT(Fixed: New Bat.), Galaxy Tab A
Quote:
Originally Posted by Taka B. View Post
Upon launch the JOBS list shows:

Get device information = Finished
Get list of books on device = 57% = 232m 58s

The job never gets to 100%. App just closes without any error or message. Of course I am never staring at the screen if/when 100% is reached.

The books are in the library and I can view them just fine, but unless a portable reader is attached, this job restarts every time I start Calibre.
do you have a "Connect to folder" (treated as a device) set up?

Calibre does NOT scan its own library normally, but it DOES scan devices.
theducks is offline   Reply With Quote