I just bought a pocketbook 612 and after updating the firmware is encountered some problems:
bugs-problems
Updated to Firmware 2.1.3 for Pocketbook 612
After protecting configuration with password it wasn't possible anymore to access the configuration menu.
"Solution": installing Firmware 2.1.2 for Pocketbook 612 and there after reinstalling Firmware 2.1.3
Cannot disconnect pocketbook from PC in the usual manner;
(taskbar> Safely remove hardware> disconnect pocketbook. Error; Pocketbook still in use.
Disconnecting via Calibre possible, but this will not disconnect PB from PC.
I disconnect the PB by shutting it down and removing the lead from the pc.
This can lead to the next bug
- 3
Disconnecting the PB from the pc in the above mentioned way, leads to a sometimes totally blocked PB; no reaction on any key
Solution: hard reset
- 4
Sometimes the pocketbook is not recognized by the PC:
USB error code; usb root hub>unknown device. device is stopped because of error code 43.
PB was connected in reading mode to the pc, with page of book visible.
Solution; reconnecting