Quote:
Originally Posted by felonwan
dmesg command show similar situation as monitoring using lsusb command.
Code:
$dmesg |tail -f
[ 1313.594415] usb 1-1.1: new high-speed USB device number 20 using ehci_hcd
[ 1404.048454] usb 1-1.1: USB disconnect, device number 20
[ 1407.821614] usb 1-1.1: new high-speed USB device number 21 using ehci_hcd
[ 1498.275816] usb 1-1.1: USB disconnect, device number 21
[ 1502.048699] usb 1-1.1: new high-speed USB device number 22 using ehci_hcd
[ 1592.502865] usb 1-1.1: USB disconnect, device number 22
[ 1596.275901] usb 1-1.1: new high-speed USB device number 23 using ehci_hcd
[ 1686.730198] usb 1-1.1: USB disconnect, device number 23
[ 1690.502985] usb 1-1.1: new high-speed USB device number 24 using ehci_hcd
[ 1770.232255] usb 1-1.1: USB disconnect, device number 24
I'll buy a USB-TTL adapter to do the program over serial port. So, like using the k3flasher, just program the kernel and rootfs to flash? |
I was referring to the dmesg output of the
Kindle's kernel, not that of the host system.
This is the adapter I recommend:
https://www.mobileread.com/forums/sho...d.php?t=170566
Any that works at 1.8volt ttl levels will do.