MobileRead Forums - View Single Post - Difference between emulator and real device (developing uds plugin for djvu)

luite · 02-02-2010, 10:50 AM

I have already found the problem and have viewed the first DjVu files on my reader. It seems to be much faster than the PDF viewer.

I had forgotten to remove the GConf configuration that caused CTB to be trying to load evince instead of my new plugin (took me a while to figure out, I tarred the whole / filesystem onto my SD card, then extracted it over an emulator image, and then copied /etc/network/* and /etc/hostname back from the original development image). After a rm -rf /home/root/.gconf it worked fine.

I'll first reinstall the firmware (1.7.1) on my DR1000 and then test some more, to make sure I haven't forgotten to include anything. Is it correct to assume that all files in / are replaced by a firmware update, except /home/root ?

02-02-2010, 10:50 AM	#3
luite Connoisseur Posts: 82 Karma: 256 Join Date: Feb 2010 Location: Netherlands Device: dr1000	I have already found the problem and have viewed the first DjVu files on my reader. It seems to be much faster than the PDF viewer. I had forgotten to remove the GConf configuration that caused CTB to be trying to load evince instead of my new plugin (took me a while to figure out, I tarred the whole / filesystem onto my SD card, then extracted it over an emulator image, and then copied /etc/network/* and /etc/hostname back from the original development image). After a rm -rf /home/root/.gconf it worked fine. I'll first reinstall the firmware (1.7.1) on my DR1000 and then test some more, to make sure I haven't forgotten to include anything. Is it correct to assume that all files in / are replaced by a firmware update, except /home/root ?