Yes, the slots are disengaged around all four sides. But the next step is not clear, because any attempt to widen a gap on any side meets with resistance, the top part just bends, it seems, like something is holding in the middle. Maybe the tape. If I only could see it.
But "You want the tape to separate from the screen, not the Bezel" is not clear.
I probably have a wrong idea what has to be separated from what.
BTW, there was a picture somewhere where somebody made a lid to access the card without disassembling Aura every time - so it seems that the card slot is on the bottom side of the pcb, not on the inside. If so, the whole pcb should stay with the screen and only the bottom lid removed. But pcb seems to be well fastened to the bottom side.
|