View Single Post
Old 06-23-2010, 12:28 PM   #2
Nirf
Junior Member
Nirf began at the beginning.
 
Posts: 5
Karma: 10
Join Date: Aug 2008
Device: PRS-505
Oh, quick PS, when I run calibre I get two "Link hasn't been detected!" messages although calibre still runs. This makes me think I may be missing some of the required packages, but this doesn't make much sense as I've a) checked most of the major ones and b) I had the same problem when I installed from repo, and the repo install should install all the required packages automatically. Also, when I hit convert, I get a pile more "link hasn't been detected" messages. Is there any kind of debug mode for calibre where I can check what libraries seem to be missing?
Nirf is offline   Reply With Quote