View Single Post
Old 09-25-2009, 11:04 AM   #13
llsecurity
Junior Member
llsecurity began at the beginning.
 
Posts: 5
Karma: 10
Join Date: Sep 2009
Device: PRS-600
It was an upgrade installation, and I cannot remember in truth if I have used Calibre since the upgrade.

I checked into the Windows NUL device settings, located the correct registry entries and "null.sys" drivers in the correct locations, but did find that I cannot seem to output anything to NUL since the upgrade.

#~echo test > NUL gives me an error "file not found", and for the life of me I cannot find any reliable solution or even evidence that others have had this problem on the Internet.

It seems I will be going with a clean install of Win7.

I will report back as to whether or not the 0.6.13 version works on the clean install once I have tested it.

Last edited by llsecurity; 09-25-2009 at 11:05 AM. Reason: typo
llsecurity is offline   Reply With Quote