I'm not sure that you're making a good connection.
Did you see the TX "wiggle" on the voltmeter when you rebooted?
Are you sure that you haven't mixed up ground and RX.
Edit Wiggles only when it's booting.
Did you read the previous post above, I just edited it.
Use the long side of the pins at a 45° angle tensioned lightly against the pads.
If you're in doubt, just connect ground to metal and use a single pin of the RX on the USB to the TX of the Leaf2.
I just went to fastboot another couple of times.
Last edited by Renate; 12-10-2022 at 10:49 AM.
|