Thread: Glo Calibre and Shelves
View Single Post
Old 11-25-2013, 12:24 PM   #31
booklover6
Wizard
booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.booklover6 ought to be getting tired of karma fortunes by now.
 
booklover6's Avatar
 
Posts: 3,763
Karma: 3308722
Join Date: May 2008
Location: PA (USA)
Device: Kobo Aura, HD, Glo, Mini
I would like to ask a question, this seems like a good place to do so. Using a Kobo Glo with Calibre and the extended plugin. After connecting the device, it takes a while to read and sync all the data. That is not a problem.

However, on sending a new document to the device, it seems to refresh the entire thing all over again.

Is there a way to prevent it from doing that? I am not sure if I should change something in Calibre settings. I don't want it to refresh the entire device list after sending one item! (As an experiment, I have been loading tons onto the device, I am up to 3800+).

Well now that I've posted my question, it doesn't seem to be doing it. So maybe I changed what needed to be changed. Not sure what that is, though. Any ideas?

Last edited by booklover6; 11-25-2013 at 12:31 PM.
booklover6 is offline   Reply With Quote