View Single Post
Old 01-21-2013, 06:47 AM   #19
xuyn2003
Connoisseur
xuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texanxuyn2003 might easily be mistaken for a Texan
 
Posts: 71
Karma: 18140
Join Date: Jul 2011
Device: PRS-T1&KOBOTOUCH
Quote:
Originally Posted by KevinShort View Post
I've noticed that if I plug my Glo into a USB cable and turn the frontlight on and then off that the LEDs will often go dimmer than the lowest level for a few seconds. I'd say that it's about half as bright as the lowest setting, and hardly noticeable in a bright room.
I teset it as follow steps, got failure:

1.when the frontlight is off, pluged the usb into GLO, GLO asked me if I want to connect to pc?
2.I chose cancel, then pressed the light button, the led is on.
3.I pressed the light button again, the led is just off.
4.Unconnected the usb, turn on the led, the light didn't go to a dimmer level.

What's wrong with the above steps?

Last edited by xuyn2003; 01-21-2013 at 06:51 AM.
xuyn2003 is offline   Reply With Quote