View Single Post
Old 11-18-2012, 09:43 AM   #6
geekmaster
Всё гениальное просто.
geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.
 
geekmaster's Avatar
 
Posts: 5,066
Karma: 6789001
Join Date: Nov 2011
Location: Щедрость не имеет пределов.
Device: *.*
Quote:
Originally Posted by h1uke View Post
sorry, this is not a solution yet, but I'm pretty sure that by using a proper factory cable
one can put their KPW directly into a Diag Mode.
Analyzing the u-boot source code and 34708 PMIC datasheet almost confirmed that.
I already made a cable, but couldn't find a proper resistor around.. later.
That "factory cable" at your first link is just a homebrew microUSB cable, with the addition of a 1K resistor on the ID pin. Does the PW support that? It would be great if this can be done with such a cable.

Some "host mode" adapter cables already have such a jumper. It could be interesting to see if one of those can be used. EDIT: No, the ID pin connects to GND on an OTG host mode cable, but in a factory cable it connects to +5v.

Last edited by geekmaster; 11-18-2012 at 10:19 AM.
geekmaster is offline   Reply With Quote