Thread: K3 lv Serial Cable
View Single Post
Old 11-01-2012, 02:06 PM   #63
geekmaster
Всё гениальное просто.
geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.geekmaster ought to be getting tired of karma fortunes by now.
 
geekmaster's Avatar
 
Posts: 5,070
Karma: 6789001
Join Date: Nov 2011
Location: Щедрость не имеет пределов.
Device: *.*
Quote:
Originally Posted by knc1 View Post
Putting the grooves in the plastic tab to position the contacts is beyond the limits of the engraving tools I have access too.

Time for "Plan B".

"Plan A" did result in my having a nice little 18 x 18 work table. So it was not a total loss.

Edit:
"Plan B" - not so good.
Plastic sheet stock arrives tomorrow, will try using that next.
Would pressing heated wires into the plastic work to make the grooves? Then remove wires, sand plastic surface flat, and attach wires into grooves. Worth a try, perhaps.
geekmaster is offline   Reply With Quote