Thread: K3 lv Serial Cable
View Single Post
Old 11-01-2012, 01:19 PM   #62
knc1
Helpdesk Junkie
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 7,831
Karma: 6975338
Join Date: Feb 2012
Device: Too many.
Putting the grooves in the plastic tab to position the contacts is beyond the limits of the engraving tools I have access too.

Time for "Plan B".

"Plan A" did result in my having a nice little 18 x 18 work table. So it was not a total loss.

Edit:
"Plan B" - not so good.
Plastic sheet stock arrives tomorrow, will try using that next.

Last edited by knc1; 11-01-2012 at 01:50 PM.
knc1 is online now   Reply With Quote