View Single Post
Old 10-12-2012, 09:45 PM   #103
twobob
( ͡° ͜ʖ ͡°){ʇlnɐɟ ƃǝs}Týr
twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.
 
twobob's Avatar
 
Posts: 6,552
Karma: 6021146
Join Date: Jun 2012
Location: uti gratia usura (Yao ying da ying; Mo ying da yieng)
Device: PW-WIFI|K5-3G+WIFI| K4|K3-3G|DXG|K2| Rooted Nook Touch
Helpful, thanks

I have the x11 support completed now, and the TSlib built, and a few other sundries it was after, still not completely happy with the config.log (will check it again) but the built SDL does happily now grab the FB via X, manage screen updates (at what look like at least 25 frames a second), and doesn't complain about anything (yet)

TS support not yet tested, I endurance tested the 5 - and circa 5-6 hours of continuous play will drain the device to recharge levels.

Still ongoing. Looks like plumbing your video code into SDL is the smart choice then.
X11 support for those devices that have it, and fbcon support for those that don't.
Or possibly fbcon for both. time will tell.

I have a very dead 5 in front of me so resuming testing tomorrow.

nano /etc/fb.modes (on the 3)
possible to support a 4 bit mode you think directly via declaration in the SDL fbcon video code you think? I'll have a dig if I get time.

Quote:
mode "600x800-0"
# D: 0.000 MHz, H: 0.000 kHz, V: 0.000 Hz
geometry 600 800 600 800 4
timings 0 0 0 0 0 0 0
accel false
rgba 0/0,0/0,0/0,0/0
endmode

mode "600x800-0"
# D: 0.000 MHz, H: 0.000 kHz, V: 0.000 Hz
geometry 600 800 600 800 8
timings 0 0 0 0 0 0 0
accel false
rgba 0/0,0/0,0/0,0/0
endmode

mode "600x706-0"
# D: 0.000 MHz, H: 0.000 kHz, V: 0.000 Hz
geometry 600 706 600 706 4
timings 0 0 0 0 0 0 0
accel false
rgba 0/0,0/0,0/0,0/0
endmode

Last edited by twobob; 10-12-2012 at 09:57 PM. Reason: nano /etc/fb.modes (on the 3)
twobob is offline   Reply With Quote