Originally Posted by geekmaster
Ahh... So it is NOT dependent on the firmware image flashed to it, but rather just dependent on its serial number. Right?
At the enable/dis-able level it is serial number dependent.
At the success/fail level - - -
If any of this update does not find the checksum correct on the files to be replaced / patched - then it will fail.
So if there is a difference in the files between what the serial number predicts to be installed vs what the end-user put there ...
I would expect the update to fail.
Plus, notice the directions towbob posted here - -
This is not a cumulative update, its an incremental - -
It must be applied to 3.3 - -
And 3.3 must be applied to 3.2 - -
And 3.2 must be applied to 3.1 - -
Grumble, Curse, etc.