I don't know why you made a new thread when I just wanted a one sentence answer from someone, which is why I asked in the IRC and not on here (it's like I texted you and you sent your reply via snail mail, if you do this for every question I ask, there will be a lot of new theeads because I ask a lot of dumb questions and don't want to flood the message boards with them
<- added for clarity), but never mind that.
I did read that post you linked to a while ago and I asked because I want to make sure of the "bottom" and "top". Can you reference other components like "top below X" and "bottom above Y"?
And since we have a thread going, let's not waste the space. Anyone want to share how they connected the USB serial? Do I need an external power supply running 1.8V? Any specific adapter that works "out of the box"? I have a 3.3V USB ttl adapter that worked on the K2. The chipset supports 1.8V, but the adapter has jumpers only for 3.3V and 5V. Also, I was too cheap to buy a new soldering iron and my old one is very worn out so any way I can check if I soldered everything correctly and no shorts over the pads, I mean it boots and my multimeter doesn't show a connection on rxd->txd or txd->gnd and it got 1.8V successfully.